TEMPERATURE DEPENDENCE OF HEAT CAPACITY AND CHANGES IN THERMODYNAMIC FUNCTIONS OF ALLOYS OF THE Pb – Te SYSTEM
https://doi.org/10.57070/2304-4497-2022-4(42)-3-10
Abstract
Lead, in comparison with other metals, has low chemical activity and high corrosion resistance. Complex alloying of lead with antimony, tellurium and copper in optimal concentrations made it possible to obtain highly effective alloys for protective cable sheaths. Pb – Sb – Cu – Te lead alloy provides the cable sheath with high resistance to fatigue, creep and active deformation in a wide temperature range, as well as good manufacturability. The basis for such a complex of positive characteristics is a specific fine-grained thermostable structure, which determines the stability of properties in operation. Alloys of this composition are at the level of world standards: they have the best complex of operational and technological characteristics compared to the most promising domestic and foreign analogues. In the work, the heat capacity of the alloys of the Rb – Te system was determined in the "cooling" mode by the known heat capacity of a reference sample made of copper grade M00. Polynomials describing the temperature dependence of the heat capacity and changes in the thermodynamic functions of alloys are obtained. It is found that with increasing temperature and tellurium content, the heat capacity, enthalpy and entropy of lead increase slightly, and the Gibbs energy values decrease.
About the Authors
Saidmiri KhudoiberdizodaTajikistan
Senior Researcher
Izatullo Ganiev
Tajikistan
Academician at NAST, doctor of chemical sciences, professor
Bakhtier Eshov
Tajikistan
Doctor of Engineering Science, associate lecturer, director
Nukra Mulloeva
Candidate of Chemical Sciences, head of the laboratory
Sukhrob Otadzhonov,
Senior lecturer of the Department of General Physics and Solid State
References
1. Ганиев И.Н., Норова М.Т., Эшов Б.Б., Иброхимов Н.Ф., Иброхимов С.Ж. Влияние добавок скандия на температурную зависимость теплоемкости и изменений термодинамических функций алюминиево-магниевых сплавов // Физика металлов и металловедение. 2020. Т. 121. № 1. С. 25–31.
2. Ганиев И.Н., Одинаев Ф.Р., Сафаров А.Г., Якубов У.Ш., Кабутов К. Температурная зависимость теплоемкости и термодинамических функции сплава АЖ 4.5 легированного висмутом // Металлы. 2020. № 1. С. 21–29.
3. Ганиев И.Н., Назарова М.Т., Якубов У.Ш., Сафаров А.Г., Курбонова М.З. Влияния лития на удельную теплоемкость и изменение термодинамических функции алюминиевого сплава АБ1 // Теплофизика высоких температур. 2020. Т. 58. № 1. С. 55–60.
4. Ганиев И.Н., Назарова М.Т., Курбонова М.З., Якубов У.Ш. Влияния натрия на удельную теплоемкость и изменение термодинамических функции алюминиевого сплава АБ1 // Известия Санкт-Петербургский государственный технологический институт (технический институт). 2019. № 51 (77). С. 2–30.
5. Ганиев И.Н., Якубов У.Ш., Назарова М.Т., Курбонова М.З. Влияние добавок калия на температурную зависимость теплоемкости и изменений термодинамических функций алюминиевого сплава АБ1 // Вестник Казанского государственного технического университета им А.Н. Туполева. 2019. Т. 75. № 4. С. 16–22.
Review
For citations:
Khudoiberdizoda S., Ganiev I., Eshov B., Mulloeva N., Otadzhonov, S. TEMPERATURE DEPENDENCE OF HEAT CAPACITY AND CHANGES IN THERMODYNAMIC FUNCTIONS OF ALLOYS OF THE Pb – Te SYSTEM. Bulletin of the Siberian State Industrial University. 2022;(4):3-10. (In Russ.) https://doi.org/10.57070/2304-4497-2022-4(42)-3-10